it Italian en English

Contact now

invalid value
invalid value
invalid value
invalid value
invalid value
invalid value
invalid value
invalid value
invalid value
invalid value
invalid value

Laying panelsParticular care must be attention to the installation of radiant panels, to minimize material waste.
After posed the band perimeter insulation as described in the previous article you can proceed with the paneling.

The laying of the insulating layer must be from perimeter tape making sure that the edges in contact with the tape are covered by the strip of transparent nylon. Firmly join the panels with each other, taking advantage of the specific side to overlap MF, so as to avoid the formation of empty spaces between one element and another.

First to start you need to choose a sense of speed: it is advisable to lay the panels parallel to the outer wall or the back wall opposite the door.


Scheme laying panels

It starts with the laying the first panel from one of the two corners of the bottom wall and proceed to form a line: if the remaining space is not sufficient for a full panel, a panel cut to embed it in the available space.

After you go to the next row with the panel portion of the previous row (see figure); continue repeating the same process row by row to complete the paneled surface.

If the last row space and small cutting the panels to achieve the desired width.

Check out the price of your radiant system

Rossato Group Srl
Headquarters: Via del Murillo, km 3.500 - 04013 Sermoneta LT - Italy
registered address via Migliara 49, No. 9 - 04016 Sabaudia LT - Italy
Cap. Soc. € 119.900,00 iv - n. LT-107494 REA - VAT-CF IT01745300598

Schedule
From Monday to Friday
Morning 8: 30 - 12: 30
Afternoon 13: 30 - 17: 30